Operands related to linkage to JP1

192) pd_jp1_use = Y | N

Specifies whether events such as HiRDB startup and termination are to be registered into JP1. For details about HiRDB events that can be registered, see the HiRDB Version 9 Installation and Design Guide.

Y: Registers HiRDB events in JP1.

N: Does not register HiRDB events in JP1.

Note: Windows (x64) does not support event notification to JP1. If Y is specified in this operand for Windows (x64), the KFPS04605-W message is displayed during HiRDB startup.

193) pd_jp1_event_level = 1 | 2

Specifies the HiRDB event types (basic or extended attribute) that are registered in JP1. For details about basic and extended attributes, see the HiRDB Version 9 Installation and Design Guide.

1: Registers only the basic attributes.

2: Registers both the basic and extended attributes.

Condition: This operand is valid when Y is specified for the pd_jp1_use operand.

Specification guidelines

Extended attributes can be registered only when the HiRDB version is 07-02 or later.
In the case of Windows (x64), this operand cannot be specified.

194) pd_jp1_event_msg_out = Y | N

Specifies whether to register message-outputting events in JP1.

Y: Registers message-outputting events.

N: Does not register message-outputting events.

Condition: This operand is valid when Y is specified for the pd_jp1_use operand.

Specification guidelines: Specify this operand if you want to reduce the number of registrations in JP1 when the volume of messages output by HiRDB is large.

2.2.36 Operands related to linkage to JP1