During system building, the HiRDB administrator uses one of the following methods to create HiRDB system definition files:
- Simple setup tool
- For details about how to create HiRDB system definition files with the simple setup tool, see the HiRDB Version 9 Installation and Design Guide.
- OS editor
- HiRDB system definition files can be created under %PDDIR%\conf with an OS editor and specification of required operands in the HiRDB system definitions.
- Batch file (SPsetup.bat) (Windows edition only)
- Executing the batch file creates HiRDB system definition files automatically under %PDDIR%\conf.
For details about creating HiRDB system definition files, see the HiRDB Version 9 Installation and Design Guide. For details about the operands of the HiRDB system definitions, see the manual HiRDB Version 9 System Definition.
- After creation of a HiRDB system definition
- You can use the pdconfchk command to check the operands of a HiRDB system definition. This command checks the integrity of the specifications of the definition operands that are required to start HiRDB. We recommend that you execute the pdconfchk command after a HiRDB system definition is created (especially when an OS editor was used to create the HiRDB system definition).
All Rights Reserved. Copyright (C) 2015, Hitachi, Ltd.