Function

The hdspathlist command specifies the Datareplicator directory on a machine that is to be subject to monitoring when JP1/Cm2 is used for operations management. The supervisor machine monitors the Datareplicators that correspond to the directories specified in the hdspathlist commands.

Only the superuser can execute the hdspathlist command, except that general users can execute the hdspathlist -l command.

There is no need to execute the hdspathlist command at the machine subject to monitoring for a Datareplicator that does not use operations management or for Windows Datareplicator.

Format

Initializing the directories subject to monitoring

hdspathlist -i

Checking the directories subject to monitoring

hdspathlist -l [ -m hde|hds ]

Adding or deleting a directory subject to monitoring

hdspathlist { -a|-d } -m { hde|hds } -p directory-name

Options

-i

Initializes the list of directories.

-l

Checks the list of Datareplicator directories subject to monitoring. General users can execute the hdspathlist -l command.

-a

Adds a Datareplicator directory that is to be monitored.

-d

Deletes a Datareplicator directory subject to monitoring from the list of directories.

-m

Specify the type of Datareplicator to be checked, added, or deleted:

hde: Source Datareplicator

hds: Target Datareplicator

-p directory-name

~ <pathname of up to 255 single-byte characters>

Specify the complete pathname of the Datareplicator directory to be added or deleted.

Output format