Function

The hdschgstatus command changes the maximum usage rate of the import information queue file. The information changed by this command is retained beyond the termination or start of the target Datareplicator.

Format

hdschgstatus  -d data-linkage-identifier
            -c reset  -k max_ratio

Options

-d data-linkage-identifier

Specify the data linkage identifier that is to be changed.

-c reset

Specifies that the information specified in -k is to be reset.

k max_ratio

Specifies that the maximum usage rate for the import information queue file is to be changed.

Rules

If the hdschgstatus command terminates normally, it returns 0. If it terminates abnormally, it returns 1.

Notes

You can execute the hdschgstatus command only while the target Datareplicator is active. An error results if you execute it while the target Datareplicator is inactive.