If the source Datareplicator has terminated abnormally, start it normally, and then perform the procedure to modify the defined information.

To modify defined information:

1. Terminate the source Datareplicator.
2. Use a text editor to modify the defined information.
3. Start the system in a start mode that will apply the modified information, as shown in the following table.
   

   Table 5-4 Start mode that applies the modified extraction environment definition

   Operand name	Start mode that applies the modified information
   	Initial start#1	Normal start#1
   dsid	Y	--
   qufilexxx#2	Y	--
   queuesize	Y	--
   logiosize	Y	Y
   quiosize	Y	--
   extsuppress	Y	--
   ext_wait_interval	Y	Y
   extract_level	Y	Y
   int_trc_getv	Y	Y
   qufullwarn	Y	Y
   extract_delay_limit_time	Y	Y
   devicexx#3	Y	--

Legend:

Y: The start mode denoted by this column applies the operand's modified information. If the start modes of both columns apply a particular operand's modified information, either of those start modes can be used to apply the modified information.

--: Not applicable

#1

This is the start mode used to start the source Datareplicator.

#2

xxx is a value in the range from 001 to 016.

#3

xx is a value in the range from 01 to 18.