To modify defined information:

1. Terminate the source Datareplicator.
   To execute an initial start subsequently, terminate the source Datareplicator normally. If the source Datareplicator has terminated abnormally, start it normally, and then perform the procedure to modify the defined information.
   
2. Use a text editor to modify the defined information.
3. Start the system in a start mode that will apply the modified information, as shown in the following table.
   

   Table 5-3 Start mode that applies the modified extraction system definition

   Operand name	Start mode that applies the modified information
   	Initial start#1	Partial initial start#1	Normal start#1
   hdeid	Y	--	--
   extdef	Y	--	--
   sendcontrol	Y	--	--
   sendidxx#2	Y	Y	--
   senddefxx#2	Y	Y	--
   sendidxxxx#3	Y	Y	--
   senddefxxxx#3	Y	Y	--
   errfile_unique	Y	--	--
   errfilesz	Y	Y	Y
   syslogout	Y	Y	Y
   syslog_message_suppress	Y	Y	Y
   dblocale	Y	--	--
   msglocale	Y	Y	Y
   watchintvl	Y	Y	Y
   cmwaittime	Y	Y	Y
   mstservice	Y	Y	Y
   extinfonum	Y	--	--
   syncterm	Y	Y	Y
   termlevel	Y	Y	Y
   info_message_out	Y	Y	Y
   except_suppress	Y	Y	Y
   int_trc_lvl	Y	Y	Y
   int_trc_filesz	Y	Y	Y
   int_trc_rintvl	Y	Y	Y
   sendprocnum	Y	Y	Y
   smt_sendintvl	Y	Y	Y
   smt_sendintvl_scale	Y	Y	Y
   smt_editbufsize	Y	Y	Y
   smt_readbufnum	Y	Y	Y
   smt_queue_read_wait_interval	Y	Y	Y
   file_dupenv	Y	--	--
   nodecontrol	Y	--	--
   node_connection_accept	Y	Y	Y
   connection_accept_hostname	Y	Y	Y
   connection_accept_service	Y	Y	Y
   connection_accept_waittime	Y	Y	Y
   connection_retry_time	Y	Y	Y
   node_syslogout	Y	Y	Y
   send_counter_reset	Y	Y	Y
   hirdb_audit_trail	Y	Y	Y
   resource_chk_err	Y	Y	Y
   recover_info_send	Y	--	--
   recover_info_send_interval	Y	--	--
   cm_errno_check	Y	Y	Y
   node_pddir	Y	--	--
   node_pdconfpath	Y	--	--
   node_shlibpath	Y	--	--
   node_host	Y	Y	Y

Legend:

Y: The start mode denoted by this column applies the operand's modified information. If the start modes of multiple columns apply a particular operand's modified information, any one of those start modes can be used to apply the modified information.

--: Not applicable

#1

This is the start mode used to start the source Datareplicator.

#2

xx is a value in the range from 01 to 64. If you are executing a normal start, do not change any of the sendid01 to sendid64 or senddef01 to senddef64 operands.

#3

xxxx is a value in the range from 0001 to 4096. If you are executing a normal start, do not change any of the sendid0001 to sendid4096 or senddef0001 to senddef4096 operands.