A HiRDB update version has the same version number and revision number as the active HiRDB, such as 07-02, followed by a code, -mn; for example, 07-02-/A, where the underlined part is the -mn code. For versions earlier than 07-03, m can be a /, an alphabetic character (excluding I, O, and P to T) or a number, and n is an alphabetic character from A to Z. For versions 07-03 and later, m and n are both numbers.

You can switch to the HiRDB update version while the existing version of HiRDB is running. However, if you install MSCS and use the system switchover facility, and you have registered the HiRDB service in the MSCS general service, you cannot update to the HiRDB update version while running the existing HiRDB.

Organization of this section

1.4.1 Updating HiRDB

1.4.2 Prerequisites

1.4.3 Actions performed prior to updating

1.4.4 Update procedure

1.4.5 Update procedure when the system switchover facility is used

1.4.6 Cautions

1.4.7 Operation considerations

1.4.8 Related product limitations and considerations

1.4.9 Operation when an error occurs during installation