This section explains HiRDB startup and termination. To start HiRDB, you execute the pdstart command; to terminate HiRDB, you execute the pdstop command. In addition, there is a method (called automatic startup) that enables HiRDB to start automatically when the operating system starts, as well as a method for HiRDB/Parallel Servers (called reduced activation) that enables operable units to start, even if there are units that cannot start.

Organization of this section

6.6.1 Startup and termination modes

6.6.2 HiRDB automatic startup

6.6.3 Reduced activation (applicable to HiRDB/Parallel Server only)