Hitachi provides tools designed to assist you in setting up a HiRDB environment. It is highly recommend that you use one of these tools when you set up your HiRDB environment:

• Simple setup tool
• Automatic generation from a batch file (SPsetup.bat)
  

  Hint

  In general, you should use the simple setup tool to set up your HiRDB environment.

Table 6-1 shows the advantages and disadvantages of the various environment setup methods. For details about each of these setup methods, see the HiRDB Version 8 Installation and Design Guide.

Table 6-1 Advantages and disadvantages of the environment setup methods

Environment setup method	Overview	Advantage	Disadvantage
Simple setup tool	You enter HiRDB environment setup information as instructed on windows that are displayed. The HiRDB environment is then set up based on the information you provide.	This is the easiest method to use to set up a HiRDB environment. The simple setup tool assures you of being able to start HiRDB operations. It also allows you to change values already specified in the system definition.	There is a limited range of HiRDB system configurations that can be set up with the simple setup tool.
Commands1	You use HiRDB commands to set up a HiRDB environment.	This method gives you complete flexibility to set up a HiRDB system configuration in any way you wish.	A certain amount of knowledge of HiRDB is required in order to use this method. Basically, an understanding of the facilities and settings described in this manual is required. This environment setup method is more difficult than the other methods.
Batch file (SPsetup.bat)2	You execute a batch file to set up a HiRDB environment.	This is an easier method for setting up a HiRDB environment than the commands method.	There is a limited range of HiRDB system configurations that can be set up with a batch file.

1

Before you attempt to set up an actual system for production use, you should try performing a simple installation. Once you become familiar with the procedures for configuring a HiRDB system by using a sample file to set up a test system, you should be ready to set up a production-use system that is more appropriate to your needs.

For details about how to perform a simple installation, see the HiRDB Version 8 Installation and Design Guide.

2

The batch file method can be used only for a HiRDB/Single Server system. For details about how to set up a HiRDB/Parallel Server environment, see %PDDIR%\HiRDEF\readme.txt.

Note

• You cannot use the simple setup tool to set up a plug-in environment.
• A batch file automatically configures HiRDB environment setting information. The HiRDB system administrator can then make changes to the values to configure a more appropriate environment.