The error mark has already been set up. (management unit name = aa....aa, virtual server identifier = bb....bb)

aa....aa: Management unit name
bb....bb: Virtual server identifier

Description

The virtual server identifier is incorrect, or the error mark has already been set up.

The command will terminate without processing.

Action

Check the virtual server identifier. If there is no error in the virtual server identifier, execute the vmiunit status command to check the error mark setup time and error mark comments.

Specify the correct virtual server identifier, and then re-execute the command.

To change the error mark comments, execute the vmiunit unmark command to remove the error mark, and then re-execute the vmiunit mark command.