An attempt to connect with OpenTP1 has failed. (resource adapter = aa....aa, service group = bb....bb, service = cc....cc, client = dd....dd:ee....ee, RootAP CommNo = ff....ff, exception = gg....gg)

aa....aa: Resource adapter display name
bb....bb: Service group name (When service group name cannot be determined, a single-byte hyphen (-) is displayed)
cc....cc: Service name (When service name cannot be determined, a single-byte hyphen (-) is displayed)
dd....dd: IP address of OpenTP1
ee....ee: Listen port number of OpenTP1
ff....ff: CommNo of root AP information
gg....gg: Information of occurring exception

Description

An attempt is made to respond to the RPC request received by the TP1 inbound integrated functionality, but the connection with OpenTP1 has failed.

The response will be cancelled.

Action

Check that OpenTP1 is operating normally and no problem has occurred in the communication lines of OpenTP1 and TP1 inbound adapter.

If problems of temporary communication lines such as depletion of port due to concentration of load occur, connection with OpenTP1 might succeed by retrying while sending a response.

Check whether settings of the retry interval while sending response (send_retry_interval) and the retry count (send_retry_count) are appropriate.

If there is no problem in OpenTP1 and the communication line, check whether the setting of the timeout time (connection_timeout) of the send connection of the TP1 inbound adapter is appropriate.