The setup has failed. If there is not enough space on the disk, then either change the output destination or delete unnecessary files to acquire enough space on the disk. ClassName = aa....aa[ ; HandlerName = bb....bb ], path = cc....cc

aa....aa: Class name
bb....bb: Handler name
cc....cc: File path

Description

An attempt to set up the class (aa....aa) has failed.

Action

If the space available on the disk is insufficient, either change the output destination, or delete the unnecessary files to secure sufficient free space. If permission for writing the files, or permission for security file output is not available, grant these permissions.

Take action based on the following causes responsible for failure in setting up the handler:

• The available disk space is insufficient
  Delete the unnecessary files to increase the available space at the output destination or change to an output destination with available space.
  
• A read only, a running, or an open file already exists with the same name, or a file with no update permission exists
  Specify the settings to output to a file with appropriate permissions.
  
• A directory with the same name as the file name already exists, or the directory does not have write permission
  Specify the settings to output to a directory or a file with appropriate permissions.
  
• The disk device fails
  Contact the system administrator.
  The system administrator must replace the device.
  

If the above-mentioned factors are not applicable, contact maintenance personnel.