cjmsicmd list dst [-t destination-type]
                  [-tmp]
                  [-b host-name : port-number]

Displays the list of physical destinations.

If a destination type is not specified, the list of physical destinations of both queue and topic types will be displayed.

-t destination-type

Specifies a destination type. You can specify the following destination types:

• q: Queue
• t: Topic

-tmp

Displays the list of temporary physical destinations.

-b host-name : port-number

Specifies the host name and the port number by delimiting them using a colon (:)

The following is an output example of cjmsicmd list dst:

--------------------------------------------------------------------------
    Name      Type    State   Producers  Consumers           Msgs
                                           Total    Count  UnAck  Avg Size
--------------------------------------------------------------------------
JMSDEMOQueue  Queue  RUNNING  0          1          1000   451    210.0
JMSDEMOTopic  Topic  RUNNING  0          0          0      0      0.0
mq.sys.dmq    Queue  RUNNING  0          0          3999   0      702.0
 
KDAN34110-I Successfully listed destinations.

Name

This is the name of the destination created by a system or a user. mq.sys.dmq is the dead message queue created by the system.

Type

This is a destination type. There are two types; Queue and Topic. The destination of mq.sys.dmq is a queue.

State

This is the state of a destination. The normal states of a destination are RUNNING or PAUSED.

Producers

This is the number of active producers of a destination.

Consumers Total

This is the number of active consumers of a destination.

Count

This is the number of messages saved in a destination.

Msgs UnAck

This is the number of messages that do have any response in a destination.

Avg Size

This is the average size of a message.

0:

The command is terminated normally.

1:

The command is terminated abnormally.