This section describes the commands used with batch applications.

The following table lists the commands used with batch applications:

Table 3-3 List of commands used with batch applications

Command name	Function	Description	Command group
cjexecjob	Execute batch application	Executes a batch application.	--
cjkilljob	Stop batch application, or forcibly stop batch server	Stops a batch application. If an attempt to stop a batch application fails, this command forcibly stops the batch server.	--
cjlistjob	Display a list of the batch application information	Outputs the information about batch applications with standard output.	--

Legend:

--: Does not apply.

The commands in the above table can use the scheduling functionality of batch applications. For the scheduling functionality of batch applications, see 4. Scheduling Batch Applications in the uCosminexus Application Server Expansion Guide.

Hereafter, the scheduling functionality of the batch applications is called the scheduling functionality.

For the exclusive control conditions for server management commands of each system, see 3.2 Exclusive control of server management commands in the uCosminexus Application Server Application Setup Guide.

Organization of this section

cjexecjob (Execute batch application)

cjkilljob (Stop batch application or forcefully terminate batch server)

cjlistjob (Display a list of the batch application information)