uCosminexus Application Server, Operation, Monitoring, and Linkage Guide
This section describes the procedure for starting and stopping a system when you are using an N-to-1 recovery system based on the HA monitor. Note that you can use the HA monitor only in AIX, HP-UX, or Linux. You cannot use the HA monitor in Solaris.
When performing the operation using the N-to-1 recovery system based on the HA monitor, you must specify the required environment settings beforehand, such as preparing the two hosts as the active node and spare node, and registering the script for monitoring, starting, and stopping the Administration Agent in which you run the cluster service. For details on how to specify the settings, see 19.5 Settings for the N-to-1 recovery system (In UNIX).
The following commands are the commands provided by the HA monitor. For details, see the manual High-reliability System Monitoring Functionality HA Monitor.
All Rights Reserved. Copyright (C) 2013, Hitachi, Ltd.