uCosminexus Application Server, Operation, Monitoring, and Linkage Guide
19.5.3 Editing the configuration files
(1) Files to be set
The files that you must set are different for the executing node and standby node.
- In the (N number of) executing nodes
- The settings that you must be careful about in the (N number of) executing nodes are as follows:
- Files that you can set by direct editing
- You can set the following files by editing them directly:
- Setting the Administration Agent (adminagent.properties)
- Setting the Smart Agent (localaddr)
- Files that you can set with the management portal
- You can set the following files when building the execution environment of Application Server using the management portal:
- Setting Cosminexus HTTP Server (httpsd.conf)
- Setting the properties of the J2EE server (usrconf.properties)
- Setting the worker (workers.properties)
- For details on setting these files, see 17.6.3 Editing the configuration files. In the N-to-1 recovery configuration, set the IP address of the virtual host instead of the alias IP address in the host name.
- In the standby node (One node for recovery)
- The configuration file that you must be careful about in the standby node (one node for recovery) is described as follows. Note that you can set this file by editing it directly.
- Setting the properties of the J2EE server (usrconf.properties)
(2) Setting the properties of the J2EE server in the standby node
The key that you must pay attention to when setting properties in usrconf.properties in the J2EE server of the standby node is as follows:
- ejbserver.distributedtx.XATransaction.enabled
Set true to disable the light transaction.
All Rights Reserved. Copyright (C) 2013, Hitachi, Ltd.