uCosminexus Application Server, Operation, Monitoring, and Linkage Guide
This section describes how to start and stop the system when you use HA monitor-based 1-to-1 node switching system. This section also describes the starting and stopping procedure when maintenance is performed for the Management Server after starting the operations. Note that the HA monitor can only be used in AIX, HP-UX, or Linux. In Solaris, you cannot use the HA monitor.
To use the 1-to-1 node switching system for operations, you must first specify the necessary environment settings such as preparing the two hosts of the active node and spare node and registering the script for monitoring, starting, and stopping the Management Server (in the 1-to-1 node switching system of the Management Server) to be monitored by the HA monitor. For details on method of setup, see 17.6 Settings of the 1-to-1 node switching system for Application Server (In UNIX) and 17.7 Settings of the 1-to-1 node switching system of the Management Server (In UNIX).
The following table lists and describes the operations that can be executed in the 1-to-1 node switching system of Management Server and the references for the operations:
Table 17-4 Operations that can be executed in the 1-to-1 node switching system
Operation | 1-to-1 node switching system of the Management Server |
---|---|
Starting the system | 17.10.1 |
Stopping the system | 17.10.2 |
Starting and stopping the system when there is planned node switching of the executing node and the standby node | 17.10.3 |
Starting and stopping the system for maintenance | 17.10.5 |
The following commands are provided by the HA monitor. For details, see the manual Reliable System Monitoring Functionality HA Monitor.
All Rights Reserved. Copyright (C) 2013, Hitachi, Ltd.