uCosminexus Application Server, Operation, Monitoring, and Linkage Guide
![[Contents]](FIGURE/CONTENT.GIF)
![[Glossary]](FIGURE/GLOSS.GIF)
![[Index]](FIGURE/INDEX.GIF)
![[Back]](FIGURE/FRONT.GIF)
![[Next]](FIGURE/AFTER.GIF)
17.4.2 Setting the environment of the cluster server
This subsection describes the points for you to consider when specifying the settings with the management portal during integration with Windows Server Failover Cluster.
- Reference note
- To set the operating environment of the system with the management portal, you must start Management Server beforehand. Also, you must set up Management Server on the host in which you will be using Management Server for the first time. For details on setting the operating environment with the management portal, and the operating procedures and screens, see the uCosminexus Application Server Management Portal User Guide.
- Organization of this subsection
- (1) Settings in the 'Configuration definition of management domain'
- (2) Settings in the 'Environment setup of logical server'
(1) Settings in the 'Configuration definition of management domain'
Define the configuration of the host for setting the logical servers and the configuration of each logical server. At this point, set the cluster IP address in 'host name' in the Host Definition screen.
(2) Settings in the 'Environment setup of logical server'
Make a note of the following points when setting the Logical J2EE Server, Logical Web Server, and Logical Naming Service:
(a) Setting the logical J2EE server
- Host fixing
Set 'Fix' in 'Fix Host' at the following locations:
- 'Fix Host' under 'Setting the Management Agent' in the J2EE Container Settings screen
- 'Fix Host' in the EJB Container Settings screen
- 'Fix Host' under 'Connecting to the Web Server' and 'Setting the server for management' in the Web Container Settings screen
When you fix the host, the host name defined in the 'Configuration definition of management domain' will be used.
- Setting the global transaction
Specify the following settings when using a global transaction:
- Set 'Light transaction functionality' to 'Disable' in the Transaction Settings screen.
- Specify the directory of the shared disk device in the 'Status file storage destination of in-process OTS' in the Transaction Settings screen.
Setup example
L:\Group1\otsstatus
(b) Setting the Logical Web Server
Set 'Fix' in 'Fix Host' in the Web Server Settings screen.
(c) Setting the Logical Naming Service
Set 'Fix' in 'Fix Host' in the Naming Service Settings screen. At this point, do not check the 'Use the host of Administration Agent as fixed host' checkbox when setting the Naming Service (started as an out-process) used by the J2EE server. By specifying the settings in this way, the host name specified in the Adding Naming Service screen of 'Configuration definition of management domain' is used.
All Rights Reserved. Copyright (C) 2013, Hitachi, Ltd.