uCosminexus Application Server Overview

[Contents][Index][Back][Next]

3.2.2 Building and operating a system by installing Application Server in the production environment

The following figure shows the manuals to be referenced for building and operating a system by installing Application Server in the production environment.

Figure 3-4 Sequence for reading to build and operate a system by installing Application Server in the production environment

[Figure]

When installing Application Server in the production environment, the manuals to be referenced differ depending on whether you are building a system that is supported for a virtual environment. For building a system for a physical environment and not a virtual environment, first see the Application Server System Setup and Operation Guide. This manual describes the procedure for building and operating a system corresponding to the general system configuration when installing Application Server.

However, a part of the system configuration cannot be built and operated based on only the contents described in the Application Server System Setup and Operation Guide. In such cases, see the contents of the Application Server System Setup and Operation Guide and if required, see the Application Server System Design Guide.

For building a system corresponding to the virtual environment, see the Application Server Virtual System Setup and Operation Guide.

Note that individual settings are required depending on the functions used for building and operating a system with any method. For details on individual settings, see the manual that explains about the functions used.

For details on the objectives of a system and the functions used and the corresponding manuals, see section 5. Objective-wise Introduction to Functions of Application Server. This section describes the functions corresponding to the following objectives and the method of reading the manuals when these functions are used: