Job Management Partner 1/Software Distribution Client Description and User's Guide

rdssysmig

The rdssysmig command converts the system configuration information of JP1/Software Distribution Client.

Description

This command converts the system configuration information to the format that is used when CLIENT_KEY=HOSTID is specified in the operating-environment settings file. Once you have set the CLIENT_KEY entry to HOSTID in the operating-environment settings file, always execute the rdssysmig command to convert the system configuration information located on the relay system.

Format

rdssysmig

End code

End code Meaning

0 Terminated normally.

1 The user who issued the command is not a superuser.

2 A system error occurred.

3 JP1/Software Distribution Client is active.

4 The CLIENT_KEY entry in the operating-environment settings file is not set to HOSTID.

99 Command processing terminated because of signal reception.

End code	Meaning
0	Terminated normally.
1	The user who issued the command is not a superuser.
2	A system error occurred.
3	JP1/Software Distribution Client is active.
4	The CLIENT_KEY entry in the operating-environment settings file is not set to HOSTID.
99	Command processing terminated because of signal reception.

Notes

Execute this command while JP1/Software Distribution Client is stopped.

[Contents][Back][Next]

[Trademarks]