Checks a character position in a specific control on the active window.

integer AIT_VerifyCharPos  (
  string strCaption,     // Control's caption
  integer nCtrlType,     // Control type
  integer nVerifyPos     // Character position
);
integer AIT_VerifyCharPos  (
  integer nCtrlID,       // Control ID
  integer nCtrlType,     // Control type
  integer nVerifyPos     // Character position
);

strCaption (input)

Specify the caption of a control.

nCtrlID (input)

Specify a control ID.

nCtrlType (input)

Specify a control type for which only EDIT_CTRL is valid.

nVerifyPos (input)

Specify the positional value of a character to be checked. Because 0-based positioning is used, the position of the first character in the edit box is 0.

The return value is 1 if the found position is the same as a specified one, 0 if not, and -1 if the function has not been processed normally. If -1 has been returned, you can use AIT_GetLastError to acquire an extended error code. The following gives the error codes that AIT_GetLastError may return.

Extended error number	Error code
8	ERROR_NOT_ENOUGH_MEMORY
14	ERROR_OUTOFMEMORY
87	ERROR_INVALID_PARAMETER
112	ERROR_DISK_FULL
1400	ERROR_INVALID_WINDOW_HANDLE
1460	ERROR_TIMEOUT

You can identify the control by using a complete caption or an associated label name or specifying the first part of such a caption or label name. When specifying the first part, prefix a swung dash (~) to the character string that you specify.