Job Management Partner 1/File Transmission Server/FTP Description, Reference and Operator's Guide

3.17.1 Definition method

To define the information to be displayed in the FTP connection response message:

1. In the ftsutil command, specify FTP connection response message control in CHECK.
   

   

2. In the FTP connection response message file (ftsbanner), specify a character string for the FTP connection response message.
   To specify a desired character string for the FTP connection response message, use a text editor to specify the character string in the FTP connection response message file (ftsbanner) according to the following definition method:
   

   

Notes

• The FTP connection response message file consists of one or more lines.
• The maximum length of one line is 256 bytes. Any characters in excess of this limit are ignored.
• The maximum file size is 512 bytes. If the file size exceeds 512 bytes, the file is ignored.
• A line consisting of only a linefeed is valid.
• No comment can be defined.
• If the file size is 0 bytes, the file is ignored.
• Some restrictions might apply to the response message format depending on the FTP client that is connected. For this reason, you must specify a response message in the FTP connection response message file in a format that will be recognized by the target FTP client.
• The attributes of the FTP connection response message file are shown below.
  

  Table 3-22 Attributes of the FTP connection response message file (ftsbanner)

  Item name	Setting
  File name	ftsbanner
  Directory name	/var/opt/jp1_fts/sys
  Owner	Superuser
  Access permission	Owner: r

[Contents][Back][Next]

All Rights Reserved. Copyright (C) 2010, Hitachi, Ltd.