Job Management Partner 1/File Transmission Server/FTP Description, Reference and Operator's Guide

3.13.1 Registering host names

Use a text editor to specify host names in the definition file (jp1ftphost.access_list) according to the definition method described below.

Begin by specifying a definition name, and then specify values on the following lines. If you specify multiple values, make sure that you specify only one value on each line. Any characters following a hash mark (#) through a linefeed are treated as a comment.

The following table lists and describes the definition names and values that can be specified.

Table 3-13 Definition names and values that can be specified in the definition file (jp1ftphost.access_list)

Definition name Description Value

[allow_list] Specifies hosts whose connection is to be permitted. IP address or host name

[deny_list] Specifies hosts whose connection is to be rejected. IP address or host name

The attributes of this definition file are shown below.

Table 3-14 Attributes of the definition file (jp1ftphost.access_list)

Item name Setting

File name jp1ftphost.access_list

Directory name /var/opt/jp1_fts/sys

Owner Superuser

Access permission Owner: r

Example

Definition name	Description	Value
[allow_list]	Specifies hosts whose connection is to be permitted.	IP address or host name
[deny_list]	Specifies hosts whose connection is to be rejected.	IP address or host name

Item name	Setting
File name	jp1ftphost.access_list
Directory name	/var/opt/jp1_fts/sys
Owner	Superuser
Access permission	Owner: r

[Contents][Back][Next]

[Trademarks]