Job Management Partner 1/File Transmission Server/FTP Description, Reference and Operator's Guide

3.4 Registering transmission information

You register information about a transmission (such as the remote host name, remote user name, and transmission file) onto a transmission card. You can also specify a program that is started by the client when transmission finishes.

To register transmission information, you execute the ftsclient command at the client and then specify the necessary information in the Registration And Execution Of Transmission Requests window. Alternatively, you can use the ftsregc command.

Note

Because Linux does not support the ftsclient command, you must use the ftsregc command in Linux.
How to display the Registration And Execution Of Transmission Requests window

For details about the permissions required for command execution, see List of commands in 6. Commands.

Execute the following command:
ftsclient
The Registration And Execution Of Transmission Requests window appears. The following figure shows the Registration And Execution Of Transmission Requests window.

Figure 3-8 Registration And Execution Of Transmission Requests window
Organization of this section

3.4.1 Registering transmission information onto a transmission card

3.4.2 Changing the information registered on a transmission card

3.4.3 Deleting transmission cards

3.4.4 Checking the contents of a transmission card

[Contents][Back][Next]

[Trademarks]