Job Management Partner 1/File Transmission Server/FTP Description, Reference and Operator's Guide

3.3 Registering auto-start programs

You can register a program to start at the server after file transmission is finished.

To register auto-start programs, you execute the ftsauto command to open the Auto-Start Program Registration window. Alternatively, you can use the ftsautoma command.

Note

Because Linux does not support the ftsauto command, you must use the ftsautoma command in Linux.
How to display the Auto-Start Program Registration window

For details about the permissions required for command execution, see List of commands in 6. Commands.

Execute the following command:
ftsauto
 
The following figure shows the Auto-Start Program Registration window.

Figure 3-2 Auto-Start Program Registration window
Organization of this section

3.3.1 Registering auto-start programs

3.3.2 Changing auto-start programs

3.3.3 Deleting auto-start programs

3.3.4 Checking the registered information about auto-start programs

3.3.5 Changing how information is displayed in the Auto-Start Program Registration window

[Contents][Back][Next]

[Trademarks]