Job Management Partner 1/Automatic Job Management System 3 Command Reference 2

[Contents][Glossary][Index][Back][Next]

4.1.2 Notes on defining unit definition parameters

The information to be defined in the file differs depending on what type of unit you want to define.

This subsection first explains which definitions are required to determine a unit. Then, this subsection explains how to specify each definition.

The unit you want to define is related to the required definition as summarized in Table 4-1. Note that definitions 1-8 in Table 4-1 refer to the following:

Definition 1
Attribute definition

Definition 2
Unit configuration definition

Definition 3
Job group definition

Definition 4
Jobnet definition

Definition 5
Job definition
The following jobs are covered:
  • UNIX/PC job
  • QUEUE job
  • Judgment job
  • JP1 event reception monitoring job
  • File monitoring job
  • Email reception monitoring job
  • Message-queue message reception monitoring job
  • MSMQ message reception monitoring job
  • Log file monitoring job
  • Windows event-log monitoring job
  • Execution interval control job
  • JP1 event sending job
  • Email sending job
  • Message-queue message sending job
  • MSMQ message sending job
  • OpenView Status Report job
  • Local power control job
  • Remote power control job
  • UNIX/PC custom job

Definition 6
Manager unit definition
The manager unit is a combination of a manager job group and a manager jobnet.

Definition 7
Start condition definition

Definition 8
Jobnet connector definition

Table 4-1 Required definitions

[Figure] Definition 1 Definition 2 Definition 3 Definition 4 Definition 5 Definition 6 Definition 7 Definition 8
Job group Yes Yes Yes#3 -- -- -- -- --
Jobnet Yes Yes -- Yes#3 -- -- -- --
Job#1 Yes -- -- -- Yes -- -- --
Manager unit#2 Yes -- -- -- -- Yes -- --
Start condition Yes -- -- -- -- -- Yes --
Jobnet connector Yes -- -- -- -- -- -- Yes

Legend:
Yes: Necessary
--: Unnecessary

#1
For the types of jobs, see the explanation of Definition 5 above.

#2
For the types of manager units, see the explanation of Definition 6 above.

#3
To use a jobnet connector to control the execution order of a root jobnet or a root jobnet that is immediately under a planning group, you must specify the execution order control method for jobnet connectors.

For an explanation of how to specify each definition, see 4.2 Definition format and parameters.

[Contents][Back][Next]

[Trademarks]

Copyright (C) 2009, 2010, Hitachi, Ltd.
Copyright (C) 2009, 2010, Hitachi Solutions, Ltd.