Job Management Partner 1/Automatic Job Management System 3 Command Reference 2

1.5.5 Commands used to operate execution agents

The following table lists the commands used to operate execution agents.

For details about the following table lists the commands used to operate execution agents, see 2. Commands in the manual Job Management Partner 1/Automatic Job Management System 3 Command Reference 1.

Table 1-12 Commands used to operate execution agents

Function	Command name	Windows	UNIX	Required privileges	Supported products
Adds an execution agent.	ajsagtadd	Y	Y	JP1_JPQ_Admin	M
Deletes an execution agent.	ajsagtdel	Y	Y	JP1_JPQ_Admin	M
Outputs information such as the job execution status on an execution agent to the standard output.	ajsagtshow	Y	Y	JP1_JPQ_Admin JP1_JPQ_Operator JP1_JPQ_User or Windows: Administrators UNIX: Superuser	M
Changes the execution agent settings or the job transfer restriction status.	ajsagtalt	Y	Y	JP1_JPQ_Admin JP1_JPQ_Operator	M
Outputs execution agent definition information in CSV format to the standard output file.	ajsagtprint	Y	Y	JP1_JPQ_Admin JP1_JPQ_Operator JP1_JPQ_User or Windows: Administrators UNIX: Superuser	M

Legend:

Y: Supported

M: JP1/AJS3 - Manager

Note

On a Windows Server 2008 host, before you execute a command that must be executed by a member of the Administrators group, make sure that you open the Command Prompt window as an administrator. To do this, on the Windows Start menu, right-click Command Prompt, and then choose Run as administrator. If the UAC function is disabled, you do not need to open the Command Prompt window as an administrator.

[Contents][Back][Next]

Copyright (C) 2009, 2010, Hitachi, Ltd.
Copyright (C) 2009, 2010, Hitachi Solutions, Ltd.