Job Management Partner 1/Automatic Job Management System 3 Operator's Guide

11.5.8 Changing the lightness of colors of units that are not highlighted units (base units and preceding and succeeding units)

You can change the lightness of the colors used for units that are not base units, preceding units, or succeeding units when those units are highlighted in the map area in the Jobnet Editor window. The same lightness level also applies to relation lines between units that are not base units and preceding and succeeding units.

The following table describes the lightness levels and their corresponding transparency.

Table 11-7 Lightness levels and corresponding transparency

Level	Transparency (%)	Remarks
0	0	The unhighlighted units and relation lines are displayed in the normal manner, not in lighter hues.
1	10	--
2	20	--
3	30	--
4	40	--
5	50	--
6	60	--
7	70	--
8	80	Default setting
9	90	--
10	100	The unhighlighted units and relation lines are displayed in white. Note that you can select and manipulate these units, and connect or delete their relation lines. Be careful, however, that you do not perform incorrect operations or select incorrect units and relation lines.

Legend:

--: None.

Specify from:

A JP1/AJS3 - View file

For details, see 11.1.1 Individual-user customization.

Specification

Use the following format:

jajsEmphasisLightLevel=0-10 (return)

Example

The following specification uses level 5 (50% transparency) to display the units and relation lines that are not base units, preceding units, or succeeding units, or their relation lines.

jajsEmphasisLightLevel=5 (return)

[Contents][Back][Next]

Copyright (C) 2009, 2010, Hitachi, Ltd.
Copyright (C) 2009, 2010, Hitachi Solutions, Ltd.