Job Management Partner 1/Automatic Job Management System 3 Operator's Guide
Even after you start executing a jobnet, you can change the schedule of the jobnet or control the execution of the jobnet or jobs. For example, if you find an abnormality while you are monitoring the execution status, you can interrupt the execution of the jobnet or kill the jobnet. When you interrupt or kill a jobnet, you can re-execute from the desired jobnet or job.
The following table lists the types of control available for jobnets and jobs.
Table 9-1 Available control
Type of control Jobnet Job Add an execution schedule Yes No Temporarily change or restore the execution start time Yes No Immediately execute an execution schedule Yes No Temporarily cancel execution Yes Yes Hold execution or release held execution Yes Yes Temporarily change or restore the delay monitor time Yes No Temporarily change the execution priority Yes No Interrupt execution Yes No Kill execution Yes Yes Re-execute Yes Yes Change status No Yes Change registration Yes No Switch among definitions Yes No Change the execution order control method Yes No
- Legend:
- Yes: Controllable
- No: Not controllable
This section describes how to change the schedule of jobnets and control the execution of jobnets and jobs. Although the description mainly covers the operation using the Daily Schedule [Hierarchy] window, the same operation may sometimes be available from other windows. For details, see Supplementary note.
Copyright (C) 2009, 2010, Hitachi, Ltd.
Copyright (C) 2009, 2010, Hitachi Solutions, Ltd.