Job Management Partner 1/Automatic Job Management System 3 Configuration Guide 1
This section describes how to change settings that have not been covered in earlier sections.
When you set environment setting parameters, use the jajs_config command.
For details about the jajs_config command, see jajs_config in 2. Commands Used during Setup in the manual Job Management Partner 1/Automatic Job Management System 3 Command Reference 2.
- Organization of this section
- 14.7.1 Setting automatic startup and termination of the JP1/AJS3 service
- 14.7.2 Changing the JP1/AJS3 database configuration to the standard configuration without ISAM
Copyright (C) 2009, 2010, Hitachi, Ltd.
Copyright (C) 2009, 2010, Hitachi Solutions, Ltd.