Job Management Partner 1/Automatic Job Management System 3 Configuration Guide 1
When you have defined search paths for a file that is to be transferred, the location of the file can also be resolved from a relative path.
This subsection describes how to define a search path.
- Organization of this subsection
- (1) Definition procedure
- (2) Environment setting parameters
- (3) Definition example
(1) Definition procedure
- Stop the JP1/AJS3 service.
Execute the following commands to confirm that all processes have stopped:
# /etc/opt/jp1ajs2/jajs_stop#1 # /opt/jp1ajs2/bin/jajs_spmd_status # /opt/jp1ajs2/bin/ajsqlstop#2 # /opt/jp1ajs2/bin/ajsqlstatus#2
- #1:
- Confirm that automatic termination has been set.
- #2:
- This command needs to be executed only if queueless jobs are used.
- Execute the following command to set the environment setting parameters described in (2) below:
jajs_config -k definition-key "parameter-name-1"=value-1 ["parameter-name-2"=value-2]- Restart the services that you stopped in step 1.
The new settings are applied.
- Note
- Make sure that you perform the above procedure on the host on which a job operation has been requested. For example, if you use the jpqjobsub command to submit a job, perform the procedure on the host on which you execute the command.
- Note that this function is not valid for result files.
(2) Environment setting parameters
Table 14-6 Environment setting parameters used to define the search path for a file that is to be transferred
Definition key Environment setting parameter Explanation [{JP1_DEFAULT|logical-host}\JP1NBQCLIENT\PathEnv]# "All Users"= Specifies the search path for the file to be transferred. "JP1-user-name"= Specifies the search path for the file to be transferred.
- #:
- The specification of the {JP1_DEFAULT|logical-host} part depends on whether the host is a physical host or a logical host. For a physical host, specify JP1_DEFAULT. For a logical host, specify the logical host name.
For details about the definition of these environment setting parameters, see the following:
- 2.3(73) All Users in the Job Management Partner 1/Automatic Job Management System 3 Configuration Guide 2
- 2.3(74) JP1-user-name in the Job Management Partner 1/Automatic Job Management System 3 Configuration Guide 2
(3) Definition example
- Conditions:
- Search paths common to all JP1 users: /home/user1/trans1 and /home/user1/trans2
- Name of the file to be transferred: /home/user1/trans1/TransFile1
- Definition example:
- Definition of the file to be transferred in the job
Name of the file to be transferred: TransFile1
- Definition of the search paths on the host sending the submit request
jajs_config -k [{JP1_DEFAULT|logical-host}\JP1AJSMANAGER\SCHEDULER\scheduler-service\QUEUE\CLIENT\PathEnv]
"All Users"="/home/user1/trans1::/home/user1/trans2"
The specification of the {JP1_DEFAULT|logical-host} part depends on whether the host is a physical host or a logical host. For a physical host, specify JP1_DEFAULT. For a logical host, specify the logical host name.
- When these settings are specified, on the host that sends a submit request, /home/user1/trans1/TransFile1 is set as the file to be transferred.
Copyright (C) 2009, 2010, Hitachi, Ltd.
Copyright (C) 2009, 2010, Hitachi Solutions, Ltd.