Job Management Partner 1/Automatic Job Management System 3 Configuration Guide 1

11.2.2 Installation in HP-UX

This subsection describes the installation procedure in HP-UX.

Note that the names of files and directories on the CD-ROM might be different from the names used in this subsection, depending on the hardware environment. Use the actual file and directory names displayed by the ls command.

To install a JP1/AJS3 series program in HP-UX:
Log in as a superuser to the host on which you want to install the JP1/AJS3 series program. Alternatively, use the su command to become superuser.

Close all programs.
If existing JP1 series programs are running, make sure that you stop all of them.

Insert the media containing the JP1/AJS3 series program you want to install.
Execute the following command to mount the CD-ROM drive:
 
/usr/sbin/mount -F cdfs -r device-special-file /cdrom
 
In the above command, /cdrom is the mount point directory of the device special file for the CD-ROM drive. If there is no mount point directory, create one.
Note that the device special file name and mount point directory name might differ, depending on the user environment.
Execute the following command to start Hitachi Program Product Installer:
 
/cdrom/HPUX^#1/SETUP /cdrom^#2
 
Hitachi Program Product Installer starts, and the initial screen appears.

#1:

For HP-UX (IPF), this folder name is IPFHPUX.

#2:

This example assumes that the mount point directory is /cdrom.
On the initial screen, enter I.
A list of programs that can be installed is displayed.

Select the JP1/AJS3 series program you want to install, and then enter I.
The selected program is installed.
You can select a program by moving the cursor to the program, and then pressing the space bar.

When installation of the program has been completed, enter Q.
The Hitachi Program Product Installer initial screen is displayed again.
After JP1/AJS3 - Manager has been installed, check syslog for the KAVS2128-E message. If this message has been output, setup of the scheduler service has failed, in which case take action based on the KAVS2128-E message.

When the JP1/AJS3 series program has been installed, user information (the authentication server and JP1 user) and database settings have been specified. In this state, you can execute a job simply by starting the JP1/AJS3 service. Note, however, that the job will be executed with all of the default settings. For changing these settings, see 12. Setup.

[Contents][Back][Next]

[Trademarks]