Job Management Partner 1/Automatic Job Management System 3 Configuration Guide 1

6.6.3 Changing the JP1/AJS3 database configuration to the standard configuration without ISAM

This subsection describes how to change the JP1/AJS3 database configuration from the standard configuration to the standard configuration without ISAM. In JP1/AJS3 - Manager installed as a new installation, the database configuration is the standard configuration, not the standard configuration without ISAM.

To change the database configuration to the standard configuration without ISAM, copy the contents of the JP1/AJS3-Manager-installation-folder\conf\jp1ajs_hstd.conf.isamless.model file to the jp1ajs_hstd.conf file to the service configuration file storage directory. Then specify permission settings so that the jp1ajs_hstd.conf file can be loaded by the JP1/AJS3 service account. In a physical host environment, the service configuration file storage directory is JP1/AJS3-Manager-installation-folder\conf. In a logical host environment, the service configuration file storage directory is shared-disk-folder-specified-by-the-jajs_setup_cluster-command\jp1ajs2\conf.

Cautionary note:

If you change the database configuration to the standard configuration without ISAM, some functions are no longer available. For details, see 1.4 JP1/AJS3 database configurations in the manual Job Management Partner 1/Automatic Job Management System 3 Overview.

[Contents][Back][Next]

[Trademarks]