Job Management Partner 1/Automatic Job Management System 3 Configuration Guide 1

6.1.4 Changing the name of a scheduler trace log file

The default trace log file name for the scheduler service is as follows:

In Windows Server 2008:

%ALLUSERSPROFILE%\HITACHI\JP1\JP1_DEFAULT\JP1AJS2\log\tracelog (The default %ALLUSERSPROFILE% value is system-drive\ProgramData.)

In Windows Server 2003:

JP1/AJS3-Manager-installation-folder\log\tracelog

You can change the name of a scheduler trace log file by using the following procedure.

Organization of this subsection

(1) Definition procedure

(2) Environment setting parameter

(1) Definition procedure

1. In Windows Control Panel, open the Services administrative tool, and stop the following service:
   
   • JP1/AJS3 service
2. Execute the following command to set the environment setting parameter described in (2) below:
   

    
   jajs_config -k definition-key "parameter-name"=value
    

3. Restart JP1/AJS3.
   The new settings are applied to the configuration definition.
   

(2) Environment setting parameter

Table 6-3 Environment setting parameter used to change the name of a scheduler trace log file

Definition key	Environment setting parameter	Explanation
[JP1_DEFAULT\JP1AJSMANAGER]	"TRACELOGFILE"=#	Specifies the name of a scheduler trace log file.

#:

The scheduler trace information for the physical host and all logical hosts is recorded in the file specified by this parameter. To ensure that the trace information is recorded, always specify the name of a file on a local disk.

Note that the specified file is created when trace information is output. Do not specify the name of an existing file.

For details about the definition of this environment setting parameter, see 2.2(3) TRACELOGFILE in the Job Management Partner 1/Automatic Job Management System 3 Configuration Guide 2.

[Contents][Back][Next]

Copyright (C) 2009, 2010, Hitachi, Ltd.
Copyright (C) 2009, 2010, Hitachi Solutions, Ltd.