Job Management Partner 1/Automatic Job Management System 3 Configuration Guide 1
You can specify the level of messages output from scheduler services to the integrated trace log. The specification procedure is as follows.
- Organization of this subsection
- (1) Definition procedure
- (2) Environment setting parameter
(1) Definition procedure
- In Windows Control Panel, open the Services administrative tool, and stop the following service:
- JP1/AJS3 service
- Execute the following command to set the environment setting parameter described in (2) below:
jajs_config -k definition-key "parameter-name"=value- Restart JP1/AJS3.
The new settings are applied to the configuration definition.
(2) Environment setting parameter
Table 6-1 Environment setting parameter used to change the level of messages output from scheduler services to the integrated trace log
Definition key Environment setting parameter Explanation [{JP1_DEFAULT|logical-host}\JP1AJSMANAGER\scheduler-service]# "HNTRLOGLEVEL"= Specifies the level of messages to be output to the integrated trace log.
- #:
- The specification of the {JP1_DEFAULT|logical-host} part depends on whether the host is a physical host or a logical host. For a physical host, specify JP1_DEFAULT. For a logical host, specify the logical host name.
For details about the definition of this environment setting parameter, see 2.2(51) HNTRLOGLEVEL in the Job Management Partner 1/Automatic Job Management System 3 Configuration Guide 2.
Copyright (C) 2009, 2010, Hitachi, Ltd.
Copyright (C) 2009, 2010, Hitachi Solutions, Ltd.