Job Management Partner 1/Automatic Job Management System 3 System Design (Configuration) Guide

8.6 About the system block

When you change the database configuration to a standard configuration after upgrading JP1/AJS2 - Manager to JP1/AJS3 - Manager, the following operations are suppressed on physical and logical hosts while the standard configuration is being set up. This state is called a system block.

JP1/AJS3 service startup

Execution of JP1/AJS3 commands

Organization of this section

(1) When system blocks occur

(2) When system blocks are released

(1) When system blocks occur

Performing the following upgrading and setup causes the physical host and all logical hosts on JP1/AJS3 - Manager to be placed in a system block:

When JP1/AJS2 - Manager uses an ISAM database as a scheduler database, and the jajs_migrate command is used to perform data migration JP1/AJS3 - Manager in a standard configuration after an upgrade to JP1/AJS3 - Manager.

When JP1/AJS2 - Manager uses a scheduler database that is not an ISAM database, and an upgrade installation of JP1/AJS3- Manager is performed.

(2) When system blocks are released

The hosts are released from a system block when the data migration performed by the jajs_migrate command has been completed.

[Contents][Back][Next]

[Trademarks]