Job Management Partner 1/Automatic Job Management System 3 System Design (Configuration) Guide

2.3.5 Communications used in a WAN

Do not use manager-agent communication in a WAN environment.

A WAN environment (INS-C or INS-P) can be used for connections between the following programs and components, but avoid using a network where you will be charged by time or data volume:

• Between JP1/AJS3 - Manager and JP1/AJS3 - View
• Between JP1/AJS3 Console View and JP1/AJS3 Console Manager
• Between JP1/AJS3 Console Manager and JP1/AJS3 Console Agent

When using a WAN environment, reduce communication costs by means such as disabling KeepAlive (always-on connection that checks connectivity with the destination) in the environment settings. Setting devices such as routers to disconnect automatically when inactivity is detected will also reduce costs.

Monitoring from JP1/AJS3 Console View can only be performed in an online environment. Monitoring cannot be performed if the line is automatically disconnected when inactivity is detected.

In an environment where you are charged on a data volume or time basis, note the following points when monitoring from JP1/AJS3 Console View:

1. The line will remain connected.
2. Communication will be performed randomly when the status of the monitored object changes.

To reduce communications costs, therefore you must log out and terminate JP1/AJS3 Console View when not in use. Communication does not occur when no one is logged in.

[Contents][Back][Next]

Copyright (C) 2009, 2010, Hitachi, Ltd.
Copyright (C) 2009, 2010, Hitachi Solutions, Ltd.