Job Management Partner 1/Automatic Job Management System 3 Overview

3.4.8 Operations on a jobnet registered for execution with a start condition

You can perform many types of operations on a jobnet registered for execution with a start condition.

If you want to perform operations such as the forced termination or cancellation of the registration of an execution generation, perform operations according to the status of the execution generation.

To perform an operation on an execution generation in the Wait for start condition status when the start condition is not satisfied or is only partially satisfied:
Perform the operation on the monitoring generation in the Now monitoring status. The operation you perform on the monitoring generation in the Now monitoring status will apply to execution generations in the Wait for start condition status when the start condition has not been satisfied yet or is only partially satisfied.

To perform the operation on an execution generation that is in the Now running status or that is in the Wait for start condition status and is waiting for the completion of execution of the preceding generation after a start condition is satisfied:
Perform the operation directly on the execution generation.

Cancel monitoring of a monitoring generation

You can cancel monitoring while still in progress by setting the monitoring generation to Interrupted or Killed status. For details about the procedure, see 9.1.1 Stopping a jobnet that is monitoring start conditions in the Job Management Partner 1/Automatic Job Management System 3 Administration Guide.

Monitor a start condition again after monitoring has finished

You can start monitoring of the start condition again by re-registering the jobnet for execution or by adding a scheduled generation of the root jobnet. You cannot monitor the start condition again by rerunning a monitoring generation that is in the Unmonitored + Ended, Monitor terminated, or Monitor-end normal status.

For details about how to add a scheduled generation, see 9.2 Adding an execution schedule for a jobnet in the Job Management Partner 1/Automatic Job Management System 3 Operator's Guide.

Stop execution of an execution generation after the start condition is satisfied.

You can use the Execution Prohibited command to stop execution of an execution generation that is being held. This command can also stop the execution of a generation waiting for the completion of execution of the running execution generation with the start condition satisfied when concurrent execution is not specified.

For details about the procedure, see 9.5 Temporarily canceling the execution of jobnets and jobs in the Job Management Partner 1/Automatic Job Management System 3 Operator's Guide.

Hold execution of an execution generation.

To hold execution of a generation, set Hold for the execution generation in question. The execution generation will be placed in Being held status when its start condition is satisfied. For details about the procedure, see 9.6 Holding the execution of jobnets and jobs in the Job Management Partner 1/Automatic Job Management System 3 Operator's Guide.

Change an event job definition in the start conditions of a jobnet registered for execution

After a jobnet with start conditions is registered for execution, you can change the event job definition in a start condition during monitoring of the start conditions.

For details, see 9.1.2 Changing an event job definition in the start conditions of a jobnet registered for execution in the Job Management Partner 1/Automatic Job Management System 3 Administration Guide.

[Contents][Back][Next]

[Trademarks]