Job Management Partner 1/Integrated Management - Event Gateway for Network Node Manager i Description, User's Guide and Reference

Lists of commands

This section provides lists of the commands that can be used in JP1/IM - EG for NNMi. The tables indicate each command's support under Windows and UNIX as follows:

Legend:

Y: Supported

--: Not supported

#

For commands that are also available in Windows, read the footnoted instances of Superuser permissions in the Required execution permissions column of the first table below as Administrator permissions.

Following the tables, the commands are described in alphabetical order.

Commands related to startup, termination, and setup

Overview of function	Command name	Windows	UNIX	Required execution permissions
Sets up JP1/IM - EG for NNMi	jegn_setup	Y	Y	Superuser permissions#
Starts JP1/IM - EG for NNMi automatically	jegn_start (UNIX only)	--	Y	Superuser permissions
Terminates JP1/IM - EG for NNMi automatically	jegn_stop (UNIX only)	--	Y	Superuser permissions
Checks the status of JP1/IM - EG for NNMi processes	jegn_spmd_status	Y	Y	Superuser permissions#
Updates the status of JP1/IM - EG for NNMi processes	jegn_spmd_reload	Y	Y	Superuser permissions#
Specifies settings required for operation in a cluster system	jegn_setup_cluster	Y	Y	Superuser permissions#
Starts JP1/IM - EG for NNMi in a cluster system	jegn_start.cluster (UNIX only)	--	Y	Superuser permissions
Terminates JP1/IM - EG for NNMi in a cluster system	jegn_stop.cluster (UNIX only)	--	Y	Superuser permissions
Forcibly terminates JP1/IM - EG for NNMi in a cluster system	jegn_killall.cluster (UNIX only)	--	Y	Superuser permissions

Commands used for troubleshooting

Overview of function	Command name	Windows	UNIX	Required execution permission
Collects data after a problem has occurred in JP1/IM - EG for NNMi	jegn_log.bat (Windows only)	Y	--	Administrator permissions
	jegn_log.sh (UNIX only)	--	Y	Superuser permissions

[Contents][Back][Next]

All Rights Reserved. Copyright (C) 2009, Hitachi, Ltd.