Job Management Partner 1/Integrated Management - Manager Administration Guide

3.3 Notes on starting and stopping

• If you restart Event Service of JP1/Base, you must also restart JP1/IM - Manager. In addition, you must restart the JP1/IM - View that was connected. If you do not restart it, you will have problems displaying events, for example.
• If a process does not stop even after you have stopped all services of JP1/IM - Manager for a logical host, you can execute the jco_killall.cluster command to forcibly stop the process. Use this command for stopping a process only when a process does not stop after you have used a normal method and stopped the JP1/IM - Manager services.
• If you collect a large number^#1 of events during startup of JP1/IM - Manager, the startup time^#2 will lengthen in proportion to the number of events that are collected. Consequently, the JP1/IM - Manager service (in Windows) or the jco_start command (in UNIX) may time out^#3 and return an error value. In such a case, JP1/IM - Manager may appear not to be starting, but startup will be completed after a while.
  

  #1

  The number will vary depending on the event collection filtering condition and the number of events that have accumulated in the event database.

  #2

  The startup time will vary depending on the machine's performance.

  #3

  The timeout period for the JP1/IM - Manager service (in Windows) or the jco_start command (in UNIX) is 2 minutes.

• If the IM database fails to start, it may be unstable because it is in restart suspension (after the IM database fails to start, 8 is returned as the return value when the jimdbstatus command is executed).
  Factors that cause the IM database to be in restart suspension and to become unstable are as follows:
  
  • Insufficient disk capacity (not insufficient IM database capacity)
  • Insufficient memory
  If the IM database is in restart suspension and is unstable, you cannot normally stop the IM database by stopping services or executing a command. To avoid this state, you must execute the jimdbstop command with the -f option specified to forcibly stop the IM database.
  
• If you are using the IM database, start JP1/Base, the IM database service, and JP1/IM - Manager in that order.
• If you are using the IM database, stop JP1/IM - Manager, the IM database service, and JP1/Base in that order.

[Contents][Back][Next]

All Rights Reserved. Copyright (C) 2009, Hitachi, Ltd.