Job Management Partner 1/Integrated Management - Manager Configuration Guide

5.8.5 Setup for linkage with JP1/PAM

Organization of this subsection

(1) Setup for using system-monitoring objects for monitoring

(1) Setup for using system-monitoring objects for monitoring

To use a system-monitoring object of JP1/PAM, you must set JP1/PAM to issue JP1 events.

For details about the linkage setup, also see the following manual:

• Description of JP1/PAM
  See the manual Job Management Partner 1/Performance Management - Analysis Description, Operator's Guide and Reference.
  

(a) For the JP1/PA - Manager host

To perform setup at the manager where JP1/PA - Manager is installed:

1. Enable JP1 event issuance by JP1/PAM.
   Set the JP1 event issuance definition file (pamjp1ev.conf) for JP1/PAM as follows:
   
   • File to be set
     pamjp1ev.conf
     
   • Settings
     Specify Y for the settings as to whether to issue JP1 events (jp1evt_flag) and whether to issue each JP1 event (such as metricNW). For the settings as to whether to issue each JP1 event, specify Y for all events.
     jp1evt_flag=Y
     metricNW=Y
     :
     

[Contents][Back][Next]

All Rights Reserved. Copyright (C) 2009, Hitachi, Ltd.