Job Management Partner 1/Integrated Management - Manager Configuration Guide

[Contents][Index][Back][Next]

2.17.3 Settings for using the functions of Central Scope

When a new installation of JP1/IM - Manager is performed, the functions of Central Scope are disabled by default.

To use the functions of Central Scope:

  1. Create a Central Scope database.
    Execute the jcsdbsetup command.

  2. Enable Central Scope Service (jcsmain).
    Execute jcoimdef -s ON.

  3. Restart JP1/IM - Manager.

  4. Verify that Central Scope Service is running.
    Execute the jco_spmd_status command. Make sure that jcsmain is displayed as an active process.

For details about the jcsdbsetup command, see jcsdbsetup in 1. Commands in the manual Job Management Partner 1/Integrated Management - Manager Command and Definition File Reference.

For details about the jcoimdef command, see jcoimdef in 1. Commands in the manual Job Management Partner 1/Integrated Management - Manager Command and Definition File Reference.

[Contents][Back][Next]

[Trademarks]

All Rights Reserved. Copyright (C) 2009, Hitachi, Ltd.