Job Management Partner 1/Integrated Management - Manager Configuration Guide

2.17.1 Executing the setup program

To execute the setup program after you have installed JP1/IM - Manager:

1. Execute the setup program.
   
   • /opt/jp1cons/bin/jp1cc_setup
   • /opt/jp1scope/bin/jp1cs_setup
   • /opt/jp1imm/bin/imcf/jp1cf_setup

Depending on the installation status, execution of the setup program may not be required, as explained below.

• When execution of the setup program is required
  JP1/Base was uninstalled and then reinstalled.
  
• When execution of the setup program is not required
  A new installation of JP1/IM - Manager was performed.
  The same version of JP1/IM - Manager was installed by overwriting.
  

[Contents][Back][Next]

All Rights Reserved. Copyright (C) 2009, Hitachi, Ltd.