Job Management Partner 1/Integrated Management - Manager Configuration Guide

1.6 Setting the startup sequence for services

To use the startup control service in JP1/Base to set the startup sequence for the JP1 services:

Specify the startup sequence control settings.
Normally, there is no problem with the default settings, but you must customize the settings in the following cases:

JP1/Power Monitor is being used to manage starting and stopping.

The IM database is being used.

For details about the settings, see the chapter that describes the settings for the service startup and stop sequences in the Job Management Partner 1/Base User's Guide. For details about how to start the IM database, see 3.1 Starting JP1/IM - Manager in the Job Management Partner 1/Integrated Management - Manager Administration Guide.

[Contents][Back][Next]

[Trademarks]