Job Management Partner 1/Performance Management Planning and Configuration Guide

6.4.1 Setting the size of the log file for the common message log

Common message logs are output in PFM - Manager, PFM - Base, PFM - Agent, and PFM - RM. The common message log file uses by default, two 2,048-KB files. This setting is required only when you wish to change the common message log file size.

Directly edit the content of the jpccomm.ini file to change the file size. The jpccomm.ini file is stored in the following locations:

On physical hosts:

In Windows:

installation-folder

In UNIX:

/opt/jp1pc/

On logical hosts:

In Windows:

environment-directory\jp1pc

In UNIX:

environment-directory/jp1pc

The following table lists and describes the label name to be edited and the range of values that can be set in the jpccomm.ini file.

Table 6-17 Settings for the file size of the common message log ("Common Section" section in jpccomm.ini)

Setting item	Label name	Available value	Default value
Size of the file that stores the common message log (Kilobytes)	Common Msglog Size	4 - 4,096	2,048

To change the size of the common message log file:

1. Stop Performance Management programs and services.
   Stop all Performance Management programs and services that are running.
   
2. Use a text editor or a similar tool to open the jpccomm.ini file.
3. Change the size of the common message log file.
   Correct the shaded parts indicated below:
   

   

   Notes:

   • Do not enter spaces at the beginning of the coding, or before and after an equals sign (=).
   • The jpccomm.ini file contains the definition information besides the common message log file size. Change values only for Common Msglog Size in the Common Section section. Performance Management might not operate correctly if you change values other than the required items.
4. Save and then close the jpccomm.ini file.

Notes:

• You need to make the settings the same for the common message log file in all Performance Management programs running on the same host.
• To return the settings of the jpccomm.ini file to the default status at installation, copy the jpccomm.ini.model file located in the installation directory of the jpccomm.ini file into the jpccomm.ini file.

[Contents][Back][Next]

All Rights Reserved. Copyright (C) 2009, Hitachi, Ltd.