5.1.2 Installation procedure

Important note

If another version of EADS server is already installed, that EADS server will be overwritten (note that this applies only to version 03-00 or later). Before you start the installation procedure, make sure that the EADS server process is not running.

To install an EADS server:

1. Log in to the machine on which you plan to install the EADS server with root permissions.

2. Place the installation CD-ROM on the CD-ROM drive.

3. Use the OS's mount command to mount the CD-ROM file system.

   An example of using the mount command is shown below.

   For the underlined part, specify the name of the mount directory for the CD-ROM file system.

   mount -r -o mode=0544 /dev/cdrom /mnt/cdrom

4. Use Hitachi Program Product Installer's setup command to start the setup program.

   An example of using the setup command is shown below.

   For the underlined part, specify the name of the mount directory for the CD-ROM file system.

   /mnt/cdrom/X64LIN/setup /mnt/cdrom

5. In Hitachi Program Product Installer's main menu, press the I key.

   The program selection window is displayed.

6. In the program selection window, move the cursor to the program that you want to install, and then press the Space key.

   Select the program that you want to install. An at mark (@) is displayed on the left of the selected program.

7. Verify that an at mark (@) is displayed on the left of the selected program, and then press the I key.

   The following message is displayed on the last line.

   Install PP? (y: install, n: cancel)==>

8. When a message asking whether you want to install the program is displayed, press the Y key.

   Installation begins. If you press the N key, installation is cancelled and the program selection window is displayed again.

9. When a message is displayed indicating that the installation is finished, press the Q key.

   The main menu is displayed again.

10. In the main menu, press the Q key.

The installation is now finished.

To Page Top