uCosminexus Stream Data Platform - Application Framework Setup and Operation Guide
![[Contents]](FIGURE/CONTENT.GIF)
![[Index]](FIGURE/INDEX.GIF)
![[Back]](FIGURE/FRONT.GIF)
![[Next]](FIGURE/AFTER.GIF)
(1) Format
<InputAdaptorDefinition name="adaptor-name"
interval="adaptor-execution-interval"
charCode="{SJIS|MS932|EUC-JP|UTF-8|UTF-8-BOM|UTF-16BE|UTF-16BE-BOM|UTF-16LE|UTF-16LE-BOM}"
lineFeed="{CR_LF|LF}">
CB-definition
</InputAdaptorDefinition>
|
(2) Details of definition
- InputAdaptorDefinition tag (all definition information)
- Defines all input adaptor definition information.
- name="adaptor-name"
- Specifies a name for identifying the input adaptor, as 1 to 100 single-byte alphanumeric characters and the underscore (_). This name must begin with a single-byte alphabetic character. This attribute cannot be omitted. This adaptor name must be unique within the adaptor group definition.
- interval="adaptor-execution-interval"
- Specifies the interval (in milliseconds) during which the input adaptor is not executed, as an integer from 0 to 60000.
- The input adaptor's processing is stopped for the specified interval following the time the final callback defined in the input adaptor is finished until the time the first callback is started. If 0 is specified, the input adaptor's processing is not stopped. If this attribute is omitted, 0 is assumed.
- charCode="{SJIS|MS932|EUC-JP|UTF-8|UTF-8-BOM|UTF-16BE|UTF-16BE-BOM|UTF-16LE|UTF-16LE-BOM}"
- Specifies the character encoding to be used at the input source. If this attribute is omitted, MS932 is assumed.
- The table below shows the correspondences between the character encodings and the charCode attribute value.
| Character encoding |
charCode attribute value |
| Shift JIS |
SJIS |
| MS932 |
MS932 |
| EUC |
EUC-JP |
| UTF-8 (without BOM) |
UTF-8 |
| UTF-8 (with BOM) |
UTF-8-BOM |
| UTF-16 (without big endian BOM) |
UTF-16BE |
| UTF-16 (with big endian BOM) |
UTF-16BE-BOM |
| UTF-16 (without little endian BOM) |
UTF-16LE |
| UTF-16 (with little endian BOM) |
UTF-16LE-BOM |
- lineFeed="{CR_LF|LF}"
- Specifies the linefeed code to be used at the input source. If this attribute is omitted, CR_LF is assumed.
- The permitted values are as follows:
- CR_LF
Treats the combination of a CR (carriage return) and an LF (linefeed) as the linefeed code.
- LF
Treats an LF (linefeed) as the linefeed code.
- CB-definition
- You can specify the following CB definitions:
- CB definition for input
- CB definition for editing
- CB definition for sending
- For details about the CB definitions, see 9.9 CB definition in the adaptor configuration definition file.
All Rights Reserved. Copyright (C) 2011, Hitachi, Ltd.