List of commands

uCosminexus Stream Data Platform - Application Framework Setup and Operation Guide

The table below lists and describes the commands used to configure and run the system.

Table 7-1 List of commands used to configure and run the system

No.	Command name	Function
1	sdpcql	Registers a query group into the SDP server.
2	sdpcqldel	Deletes a query group on inactive or shutdown status that is registered in the SDP server.
3	sdpcqlstart	Starts a query group on inactive or shutdown status that is registered in the SDP server.
4	sdpcqlstop	Terminates a query group that is running on the SDP server.
5	sdpls	Displays information about query groups registered in the SDP server.
6	sdpsetup	Sets up an operating environment.
7	sdpstart	Starts the SDP server.
8	sdpstartap	Starts specified standard adaptors or a specified custom adaptor to run in the RMI connection mode.
9	sdpstartinpro	Starts specified standard adaptors or a specified custom adaptor to run in the in-process connection mode.
10	sdpstop	Shuts down the SDP server.
11	sdpstopap	Terminates specified standard adaptors running in the RMI connection mode.
12	sdpstopinpro	Terminates specified standard adaptors or a specified custom adaptor running in the in-process connection mode.
13	sdptplls	Displays information about the tuples collected in tuple log files.
14	sdptplput	Reloads tuples collected in the tuple log files to the input stream queue.
15	sdptrced	Edits and outputs API trace information.