Drags and drops the section from a specified start position to a specified end position.

bool AIT_MouseDragDrop  (
  integer nXStartPos,       // Start X coordinate
  integer nYStartPos,       // Start Y coordinate
  integer nXEndPos,         // End X coordinate
  integer nYEndPos,         // End Y coordinate
  integer nButton,          // Mouse button
  integer nKeyState         // Key status
); 

nXStartPos (input)

Specify the X coordinate of a position at which to start dragging.

nYStartPos (input)

Specify the Y coordinate of a position at which to start dragging.

nXEndPos (input)

Specify the X coordinate of a position at which to drop the section.

nYEndPos (input)

Specify the Y coordinate of a position at which to drop the section.

nButton (input)

Specify a mouse button to be used for dragging and dropping. You have to set one of the following values.

Value	Description
LBUTTON	Left mouse button
MBUTTON	Center mouse button
RBUTTON	Right mouse button

nKeyState (input)

Specify key status, which must be one of the following values.

Value	Description
SHIFT_ON	The Shift key is on.
ALT_ON	The Alt key is on.
CTRL_ON	The Ctrl key is on.
SHIFT_OFF	The Shift key is off.
ALT_OFF	The Alt key is off.
CTRL_OFF	The Ctrl key is off.

The return value is true if the function was executed normally, and false if not. If the function has returned false, you can use AIT_GetLastError to acquire an extended error code. The following gives the error codes that AIT_GetLastError may return.

Extended error number	Error code
8	ERROR_NOT_ENOUGH_MEMORY
14	ERROR_OUTOFMEMORY
87	ERROR_INVALID_PARAMETER
112	ERROR_DISK_FULL