Job Management Partner 1/Software Distribution Description and Planning Guide

[Contents][Glossary][Index][Back][Next]

6.6.5 Example of settings for dial-up connections

The figure below shows an example of a configuration for setting up dial-up connections. In this configuration, the following dial-up connections are used:

Organization of this subsection
(1) Phonebook settings
(2) Remote access service settings in the server
(3) Remote access permission settings
(4) JP1/Software Distribution installation and setup settings

(1) Phonebook settings

The following table shows the phonebook settings for the example.

Table 6-4 Example phonebook settings

Setting item Setting in JP1/Software Distribution Manager Settings in JP1/Software Distribution Client (relay system or client)
Entry name Sub01 Manager01
Telephone number Telephone number of JP1/Software Distribution Client (relay system) Telephone number of JP1/Software Distribution Manager

(2) Remote access service settings in the server

The following table shows the IP address settings of the hosts in the example (start and end addresses).

Table 6-5 Example of remote access service settings in the server

Setting item Setting in JP1/Software Distribution Manager Settings in JP1/Software Distribution Client (relay system) Settings in JP1/Software Distribution Client (client)
Start address 192.168.50.10 192.168.100.100 192.168.200.200
Finish address 192.168.50.13 192.168.100.101 192.168.200.201

The IP addresses of the remote access service client to be assigned to JP1/Software Distribution SubManager and JP1/Software Distribution Client should be different so that their network IDs are different.

The IP addresses of the remote access service server to be specified in JP1/Software Distribution SubManager and JP1/Software Distribution Client should also be different so that their network IDs are different.

(3) Remote access permission settings

The user name of the client who will be connecting must be selected and Grant dial-in Permission to User must be selected. The following table shows the remote access permission settings for the example.

Table 6-6 Example of remote access permission settings

Setting item Setting in JP1/Software Distribution Manager Settings in JP1/Software Distribution Client (relay system)
User name for whom login permission is to be granted User name of JP1/Software Distribution Client User name of JP1/Software Distribution Manager

(4) JP1/Software Distribution installation and setup settings

The following table shows the settings made during installation and setup of JP1/Software Distribution for the example.

Table 6-7 Example of JP1/Software Distribution installation and setup settings

Setting item Setting in JP1/Software Distribution Manager Settings in JP1/Software Distribution Client (relay system and client)
User name NETMDMJOBLOGIN NETMDMMANAGERLOGIN
Password password02 password01
Domain name Domain name of JP1/Software Distribution Client (relay system) Domain name of JP1/Software Distribution Manager

The Windows NT user name and password at each host must be the same as the settings at the connection destination.